top of page

DID YOUR WATER HEATER QUIT ON YOU? NO HOT WATER?

 

READ THROUGH ALL THE WATER HEATER FAILURE SYMPTOMS BELOW TO DETERMINE IF YOUR WATER HEATER IS REPAIRABLE. IF NOT, SELECT A WATER HEATER INSTALLATION OPTION BELOW.

water heater thermocouple.jpg

THERMOCOUPLE / THERMOPILE REPLACEMENT

If you ran out of hot water and the unit is not leaking, your water heater might be repairable. Older tank type water heaters(GE, Rheem, State) use universal thermocouples. Over time the end of the tip deteriorates and the thermocouple fails, which results in no hot water. Newer model water heaters(Bradford White, Whirlpool, AO Smith) with digital gas controls, use thermopiles. If you have problems with one of those water heaters, most likely it is bad gas control.

water heater universal gas control.jpg

GAS CONTROL REPLACEMENT

If your water heater starts, but it only heats up for a few minutes or just one heating cycle at the most- there might be a problem with the gas control. Older water heaters use the "Universal" gas control, which is interchangeable between different water heater brands. It is gray in color and made out of metal. If your water heater has a plastic gas control with blinking led light on it, this is the newer "Digital" gas control. They are very specific to the brand name and even model number. The exact replacement part is needed.

water heater connectors.png

LEAKY SUPPLY LINE REPLACEMENT

If you noticed a leak around your water heater and it seems to be coming from one of the water connectors on top of the water heater- your water heater might still be intact. If a supply line was not installed correctly or if it is from a lesser quality, soon or late it will start leaking. We will be happy to replace the water connectors of your water heater with high-quality contractor grade stainless steel flex lines. If you observe the leak to be coming from inside the tank and you can see rust, your water heater might need to be replaced.

TPVALVE.jpg

T & P VALVE REPLACEMENT

Symptoms of faulty T&P Valve:

The lever froze and you can't lift it up to release water.
The lever won't fully close allowing the water to run
Intermittent weeping and/or dribbling from the relief valve pipe end.

The temperature and pressure relief valve (T & P) is a safety device limiting temperature and pressure levels in a water heater. Each T & P has both a temperature and pressure rating. Normally, the temperature and pressure relief valve will have a temperature rating for 210°F. A probe (part of the relief valve) extends into the tank measuring the stored water temperature. This probe must be within the top six inches of the water heater. However, if the water heater’s thermostat malfunctions, higher than normal water temperatures could be produced. Once the probe senses a temperature exceeding its temperature rating, the relief valve will open to full capacity releasing “very hot” water until the temperature is below its reset temperature.

PRV.jpg

PRESSURE REGULATOR VALVES

Even if your T&P Valve is intact, you might still get an unexplained water discharge through it, if the pressure reducing valve in your home is not functioning properly. Symptoms of faulty pressure reducing valve are:

High water flow, pressure over 80 PSI, rattling and noisy pipes.

Ensuring practical, safe working water pressure, municipal and private water supply companies use pumps and pumping stations

to boost water supply pressure in an effort to be able to supply water for fire fighting, high rise buildings to overcome the loss of pressure as the elevation increases, and to maintain water supply in water towers and supply tanks. The pressure in water supply mains can exceed 200psi. Most plumbing codes require water pressure reducing valves on domestic systems, where the municipal water main's pressure exceeds 80psi. Higher pressures could rupture pipes, damage fixtures, and injure the people using them.

expansion tank.jpg

EXPANSION TANKS

Even if nothing is wrong with your T&P Valve and Pressure Regulator, there might still be unexplained water discharge at the T&P Valve due to water expansion. Larger homes equipped with hot water recirculation pumps and buildings with backflow preventers are required to utilize expansion tanks. Just like anything else, when the water is heated expands in volume. In the presence of a check valve or backflow preventer in your plumbing system, there is no room for the expanded water to flow in. This is when an expansion tank comes in to play. The expansion tank has an air chamber split by a flexible membrane, that moves to accommodate the water expansion. If you experience an unexplained water discharge, check your expansion tank by poking the air stem underneath the tank. If you get water spraying out, the expansion tank needs to be replaced. They come in different sizes, as the 2.1 gallons and the 4.5 gallons are the most common ones.

 IF YOUR WATER HEATER IS NOT REPAIRABLE, SELECT AN INSTALLATION OPTION BELOW 

EASY APPOINTMENT SCHEDULING - FILL OUT THE FORM BELLOW

Success! We will contact you shortly.

WHO WE ARE

For over a decade, we have mastered the trade of water heaters, where we have extensive experience that we are ready to deliver to your home. By hiring us you can have peace of mind, that the job will be done right the first time and your water heater will serve you well and last you for many years to come. Rest assured, you will receive the quality and service you deserve at a reasonable price. We are licensed, bonded and insured family owned local water heater company. Our trucks are fully stocked at all times with 40, 50, and 75 gallons water heaters, so we can complete the job within a single visit.
Here at USA Water Heaters, our mission is to meet and exceed customer expectations during the installations or the repairs we conduct as your water heater services provider. We always combine the usage of the best quality water heaters and materials available, with the highest quality of workmanship, and at the most reasonable and affordable price. We are driven by service, not sales and are committed to providing the highest level of service in every aspect of the process. Our goal is creating long-lasting relationships and earning your business for life. Give us a call and find out for yourself!

2008

Year Established
Over

20,000

Projects Completed
Over

20,000

Happy
Customers
da.jpg

Dennis -

Manager

B8C5BE47-B512-468E-8EAA-1E5B27174489_edited.jpg

Plamen -

Water Heater Technician

ht.jpg

Chris -

Water Heater Technician

nv.jpg

Nick -

Water Heater Technician

MEET THE TEAM

EASY APPOINTMENT SCHEDULING - FILL OUT THE FORM BELLOW

Success! We will contact you shortly.

RECENT PROJECTS

CONTACT US

Success!

Mailing Address

USA Water Heaters

3943 Irvine Blvd, 119

Irvine, CA 92602

 

office@usawaterheaters.us

Tel: 949-535-2228

Fax: 866-866-5095

Employment

We are always looking for positive and experienced water heater technicians to add to our team. Submit your resume to office@usawaterheaters.us for consideration.

bottom of page